3Dconnexion CadMouse… for Everything!
Mike loves his CadMouse, but not just for CAD. In this piece Mike share’s his 3DConnexion CadMouse setup for three commonly used applications.
Read More
Category: Design Accelerator
Inventor | Shaft Generator Calculations
Here’s a quick look at some of the less traveled features in Inventor’s Shaft Generator
Read MoreGear Generator Preparation
What’s going on In Design? Making Autodesk Inventor’s Gear Generator much easier to use.
Read MoreInventor | Some Quick Tips From A New Project
Six great tips to make your Inventor time more productive. Frame Generator, Top-Down Design, Gesturing, and View Representations
Read MoreInventor | Thoughts from the Weekend Frame Design
Here are some Autodesk Inventor tips I collected while working a simple frame design this weekend. Find out some of the things I use to make Frame Generator a success in my designs.
Read MoreInventor – Selection Order of Gears in Dynamic Simulation
Back to Mismatched Factors on Gears… It doesn’t have to be gears, but many of the...
Read MoreInventor | Mismatched Factors on Gears in Dynamic Simulation
Take a look at how to avoid Gear Generator Problems in Autodesk Inventor Dynamic Simulation
Read MoreInventor – Using Civil 3D Design constraints
Part 2 – A quick run through projecting Civil 3D geometry into our design skeleton
Read MoreInventor – Pitch Surfaces on Gears in Dynamic Simulation
See how Pitch Diameter is a critical member in Simulation Joint preparation
Read MoreInventor – Assembly Constraint Naming
Management of features and components in Inventor is kind interesting. In AutoCAD, the technician...
Read MoreInventor – Weld Gap nominal parameter
I’d like to see a way to get the Frame Generator tools to access the parameters. I am a top...
Read MoreInventor – Garin’s hole article
I was going through my RSS feeds, that are backlogged, and I ran across Garin Gardiner’s page...
Read More